Dell Alienware m15 R2 Service Manual - Page 51
Installing the power-button assembly
View all Dell Alienware m15 R2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
2. Remove the base cover. 3. Remove the 2230 solid-state drive. (if applicable) 4. Remove the 2280 solid-state drive. (if applicable) 5. Remove the rear I/O-cover. 6. Remove the battery. 7. Remove the left I/O-board. 8. Remove the right I/O-board. 9. Remove the system board. About this task The following image indicates the location of the power-button assembly and provides a visual representation of the removal procedure. Steps 1. Remove the three (M2x1.9) screws that secure the power-button bracket to the palm-rest assembly. 2. Lift the power-button bracket off the power-button assembly. 3. Peel the power-button assembly and its cable off the palm-rest assembly. Installing the power-button assembly Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following image indicates the location of the power-button assembly and provides a visual representation of the installation procedure. 51