Dell Force10 S50-01-GE-48T FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 1066

www.dell.com | support.dell.com Related Commands The configuration of IPsec encryption on an interface-level takes precedence over an area-level configuration. If you remove an interface configuration, an area encryption policy that has been configured is applied to the interface. To remove an IPsec encryption policy from an interface, enter the no area area-id encryption spi number command. - ipv6 ospf encryption show crypto ipsec policy Configure an IPsec encryption policy on an OSPFv3 interface. Display the configuration of IPsec encryption policies. clear ipv6 ospf process ce Reset an OSPFv3 router process without removing or re-configuring the process. Syntax clear ipv6 ospf process [process-id] Parameters process-id (OPTIONAL) Enter the process identification number. Command Modes EXEC EXEC Privilege Command History Version 7.8.1.0 Version 7.4.1.0 Added support for C-Series Introduced debug ipv6 ospf packet c e Display debug information on OSPF IPv6 packets. Syntax debug ipv6 ospf packet [interface] To cancel the debug, use the no debug ipv6 ospf packet [interface] command. Parameters interface (OPTIONAL) Enter one of the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series Range: 1-128 E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale. • For a SONET interface, enter the keyword sonet followed by the slot/ port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094 Command Modes EXEC Privilege 1066 | Open Shortest Path First (OSPFv2 and OSPFv3)