Dell Force10 S50-01-GE-48T FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 673

Command Modes EXEC EXEC Privilege Command History Version 8.1.1.0 Version 7.9.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on E-Series ExaScale Introduced VRF on the E-Series Introduced on S-Series Introduced on C-Series Introduced for E-Series Example Figure 24-20. show ip route all Command Example FTOS#show ip route all Codes: C - connected, S - static, R - RIP B - BGP, IN - internal BGP, EX - external BGP, LO - Locally Originated O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1 N2 - OSPF NSSA external type 2, E1 - OSPF external type 1 E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1 L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default > - non-active route + - summary route Gateway of last resort is not set Destination ----------R 3.0.0.0/8 C > R C > R FTOS# 100.10.10.0/24 100.10.10.0/24 101.10.10.0/24 101.10.10.0/24 Gateway ------via 100.10.10.10, So 2/8 via 101.10.10.10, So 2/9 Direct, So 2/8 Direct, So 2/8 Direct, So 2/9 Direct, So 2/9 Dist/Metric Last Change 120/1 00:07:12 0/0 120/0 0/0 120/0 00:08:54 00:08:54 00:09:15 00:09:15 Example Figure 24-21. show ip route summary and show ip route static Command Examples FTOS#show ip route summary Route Source Active Routes Non-active Routes connected 2 0 static 1 0 Total 3 0 Total 3 active route(s) using 612 bytes R1_E600i>show ip route static ? | Pipe through a command R1_E600i>show ip route static Destination Gateway Dist/Metric Last Change ----------- ------- *S 0.0.0.0/0 via 10.10.91.9, Gi 1/2 1/0 3d2h FTOS> IPv4 Routing | 673