Dell Force10 S50-01-GE-48T FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 353

Related Commands Command History neighbor soft-reconfiguration inbound Assign a subnet to a dynamically-configured BGP neighbor. Version 8.4.2.0 Version 7.8.1.0 Version 7.7.1.0 Added support for the match-af keyword Introduced support on S-Series Introduced support on C-Series neighbor remote-as c e s Create and specify the remote peer to the BGP neighbor. Syntax neighbor {ip-address | peer-group-name} remote-as number To delete a remote AS entry, use the no neighbor {ip-address | peer-group-name} remote-as number command. Parameters ip-address peer-group-name number Enter the IP address of the neighbor to enter the remote AS in its routing table. Enter the name of the peer group to enter the remote AS into routing tables of all routers within the peer group. Enter a number of the AS. Range: 0-65535 (2-Byte) or 1-4294967295 (4-Byte) Defaults Not configured. Command Modes ROUTER BGP Usage Information You must configure your system to accept 4-Byte formats before entering a 4-Byte AS Number. If the number parameter is the same as the AS number used in the router bgp command, the remote AS entry in the neighbor is considered an internal BGP peer entry. This command creates a peer and the newly created peer is disabled (shutdown). Related Commands router bgp bgp four-octet-as-support Enter the ROUTER BGP mode and configure routes in an AS. Enable 4-Byte support for the BGP process. Command History Version 7.8.1.0 Version 7.7.1.0 Introduced support on S-Series Introduced support on C-Series Added 4-Byte support. neighbor remove-private-as c e s Remove private AS numbers from the AS-PATH of outgoing updates. Syntax neighbor {ip-address | peer-group-name} remove-private-as To return to the default, use the no neighbor {ip-address | peer-group-name} remove-private-as command. Border Gateway Protocol IPv4 (BGPv4) | 353