Dell Force10 S50-01-GE-48T FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 1086
description, ip redirect-group
View all Dell Force10 S50-01-GE-48T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1086 highlights
www.dell.com | support.dell.com description c e s Add a description to this redirect list. Syntax description {description} To remove the description, use the no description {description} command. Parameters description Enter a description to identify the IP redirect list (80 characters maximum). Defaults No default behavior or values Command Modes REDIRECT-LIST Command History Version 8.4.2.1 Version 8.4.2.0 pre-Version 7.7.1.0 Introduced on the C-Series and S-Series Introduced on the E-Series TeraScale Introduced on the E-Series ExaScale Related Commands ip redirect-list Enable an IP Redirect List ip redirect-group c e s Apply a redirect list (policy-based routing) on an interface. You can apply multiple redirect lists to an interface by entering this command multiple times. Syntax ip redirect-group redirect-list-name To remove a redirect list from an interface, use the no ip redirect-group name command. Parameters redirect-list-name Enter the name of a configured redirect list. Defaults No default behavior or values Command Modes INTERFACE (conf-if-vl-) Command History Version 8.4.2.1 Version 8.4.2.0 Version 7.4.2.0 Version 6.5.3.0 Introduced on the C-Series and S-Series Introduced on the E-Series TeraScale Added support for LAG and VLAN interfaces Introduced on the E-Series ExaScale Usage Information Any number of redirect-groups can be applied to an interface. A redirect list can contain any number of configured rules. These rules includes the next-hop IP address where the incoming traffic is to be redirected. 1086 | Policy-based Routing (PBR)