Dell Force10 S50-01-GE-48T FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 1089
redirect, sonet, no seq, range
View all Dell Force10 S50-01-GE-48T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1089 highlights
redirect c e s Configure a rule for the redirect list. Syntax redirect {ip-address | sonet slot/port} {ip-protocol-number | protocol-type [bit]} {source mask | any | host ip-address} {destination mask | any | host ip-address} [operator] To remove this filter, use one of the following: • Use the no seq sequence-number command syntax if you know the filter's sequence number. • Use the no redirect {ip-address | sonet slot/port} {ip-protocol-number [bit] | protocol-type} {source mask | any | host ip-address} {destination mask | any | host ip-address} [operator] Parameters ip-address sonet slot/port ip-protocol-number protocol-type bit source mask any host ip-address destination operator Enter the IP address of the forwarding router. Enter the keyword sonet followed by the slot/port information. Enter a number from 0 to 255 for the protocol identified in the IP protocol header. Enter one of the following keywords as the protocol type: • icmp for Internet Control Message Protocol • ip for Any Internet Protocol • tcp for Transmission Control Protocol • udp for User Datagram Protocol (OPTIONAL) For TCP protocol type only, enter one or a combination of the following TCP flags: • ack = acknowledgement • fin = finish (no more data from the user) • psh = push function • rst = reset the connection • syn = synchronize sequence number • urg = urgent field Enter the IP address of the network or host from which the packets were sent. Enter a network mask in /prefix format (/x). Enter the keyword any to specify that all traffic is subject to the filter. Enter the keyword host followed by the IP address to specify a host IP address. Enter the IP address of the network or host to which the packets are sent. (OPTIONAL) For TCP and UDP parameters only. Enter one of the following logical operand: • eq = equal to • neq = not equal to • gt = greater than • lt = less than • range = inclusive range of ports (you must specify two ports for the port command parameter.) Defaults No default behavior or values Command Modes REDIRECT-LIST Policy-based Routing (PBR) | 1089