Dell Force10 S50-01-GE-48T FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 235

Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST Command History Version 8.2.1.0 Version 8.1.1.0 Version 7.4.1.0 Version 6.5.10 Allows ACL control of fragmented packets for IP (Layer 3) ACLs. Introduced on E-Series ExaScale Added support for non-contiguous mask and added the monitor option. Expanded to include the optional QoS order priority for the ACL entry. Usage The order option is relevant in the context of the Policy QoS feature only. See the "Quality of Information Service" chapter of the FTOS Configuration Guide for more information. When you use the log option, CP processor logs details about the packets that match. Depending on how many packets match the log entry and at what rate, the CP may become busy as it has to log these packets' details. The monitor option is relevant in the context of flow-based monitoring only. See the Chapter 44, Port Monitoring. You cannot include IP, TCP or UDP filters in an ACL configured with ARP filters. Note: When ACL logging and byte counters are configured simultaneously, byte counters may display an incorrect value. Configure packet counters with logging instead. permit ether-type e Configure a filter that allows traffic with specified types of Ethernet packets. This command is supported only on 12-port GE line cards with SFP optics; refer to your line card documentation for specifications. Syntax permit ether-type protocol-type-number {destination-mac-address mac-address-mask | any} vlan vlan-id {source-mac-address mac-address-mask | any} [count [byte] | log] [order] [monitor] To remove this filter, use one of the following: • Use the no seq sequence-number command syntax if you know the filter's sequence number or • Use the no permit ether-type protocol-type-number {destination-mac-address mac-address-mask | any} vlan vlan-id {source-mac-address mac-address-mask | any} command. Parameters protocol-type-number destination-mac-address mac-address-mask any Enter a number from 600 to FFF as the specific Ethernet type traffic to drop. Enter a MAC address and mask in the nn:nn:nn:nn:nn format. For the MAC address mask, specify which bits in the MAC address must match. The MAC ACL supports an inverse mask, therefore, a mask of ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of 00:00:00:00:00:00 only allows entries that match exactly. Enter the keyword any to match and drop specific Ethernet traffic on the interface. Access Control Lists (ACL) | 235