Dell Force10 S50-01-GE-48T FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 845

Defaults 1200 seconds Command Modes ROUTER ISIS Usage Change the maximum LSP lifetime with this command. The maximum LSP lifetime must always be Information greater than the LSP refresh interval. The seconds parameter enables the router to keep LSPs for the specified length of time. If the value is higher, the overhead is reduced on slower-speed links. Related Commands lsp-refresh-interval Use this command to set the link-state packet (LSP) refresh interval. maximum-paths e Allows you to configure the maximum number of equal cost paths allowed in a routing table. Syntax maximum-paths number To return to the default values, enter no maximum-paths. Parameters number Enter a number as the maximum number of parallel paths an IP routing installs in a routing table. Range: 1 to 16. Default: 4 Defaults 4 Command Mode ROUTER ISIS (for IPv4) CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6) Command History Version 7.8.1.0 Version 6.3.1.0 Introduced MT ISIS support Introduced metric-style e Configure a router to generate and accept old-style, new-style, or both styles of type, length, and values (TLV). Syntax metric-style {narrow [transition] | transition | wide [transition]} [level-1 | level-2] To return to the default values, enter the no metric-style {narrow [transition] | transition | wide [transition]} [level-1 | level-2] command. Parameters narrow transition Allows you to configure the E-Series to generate and accept old-style TLVs. Metric range: 0 to 63 Allows you to configure the E-Series to generate both old-style and new-style TLVs. Metric range: 0 to 63 Intermediate System to Intermediate System (IS-IS) | 845