Dell Force10 S50-01-GE-48T FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 657

Version 7.5.1.0 pre-Version 6.1.1.0 Support added for C-Series Introduced for E-Series Usage Information When a static route (or a protocol route) overlaps with Management static route, the static route (or a protocol route) is preferred over the Management Static route. Also, Management static routes and the Management Connected prefix are not reflected in the hardware routing tables. Separate routing tables are maintained for IPv4 and IPv6 management routes. This command manages both tables. Related Commands interface ManagementEthernet duplex (Management) speed (Management interface) Configure the Management port on the system (either the Primary or Standby RPM). Set the mode of the Management interface. Set the speed for the Management interface. show arp c e s Display the ARP table. Syntax show arp [vrf vrf name] [interface interface | ip ip-address [mask] | macaddress mac-address [mac-address mask]] [cpu {cp | rp1 | rp2}] [static | dynamic] [summary] Parameters vrf name cpu interface interface ip ip-address mask macaddress mac-address mask static E-Series Only: Show only the ARP cache entries tied to the VRF process. (OPTIONAL) Enter the keyword cpu with one of the following keywords to view ARP entries on that CPU: • cp - view ARP entries on the control processer. • rp1 - view ARP entries on Routing Processor 1. • rp2 - view ARP entries on Routing Processor 2. (OPTIONAL) Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For the Management interface, enter the keyword managementethernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1-128 E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. (OPTIONAL) Enter the keyword ip followed by an IP address in the dotted decimal format. Enter the optional IP address mask in the slash prefix format (/ x). (OPTIONAL) Enter the keyword macaddress followed by a MAC address in nn:nn:nn:nn:nn:nn format. Enter the optional MAC address mask in nn:nn:nn:nn:nn format also. (OPTIONAL) Enter the keyword static to view entries entered manually. IPv4 Routing | 657