Dell Force10 S50-01-GE-48T FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 769

neighbor remote-as neighbor shutdown Assign a indirectly connected AS to a neighbor or peer group. Disable a peer or peer group. neighbor peer-group passive c e Enable passive peering on a BGP peer group, that is, the peer group does not send an OPEN message, but will respond to one. Syntax neighbor peer-group-name peer-group passive To delete a passive peer-group, use the no neighbor peer-group-name peer-group passive command. Parameters peer-group-name Enter a text string up to 16 characters long as the name of the peer group. Defaults Not configured. Command Modes ROUTER BGP Command History Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 Introduced on C-Series and S4810. Introduced on E-Series ExaScale Introduced on E-Series TeraScale Usage After you configure a peer group as passive, you must assign it a subnet using the neighbor subnet Information command. Related Commands neighbor subnet Assign a subnet to a dynamically-configured BGP neighbor. neighbor remote-as c e Create and specify the remote peer to the BGP neighbor. Syntax neighbor {ipv6-address | peer-group-name} remote-as number To delete a remote AS entry, use the no neighbor {ipv6-address | peer-group-name} remote-as number command. Parameters ipv6-address peer-group-name number Enter the IPv6 address in the x:x:x:x::x format. The :: notation specifies successive hexadecimal fields of zeros. Enter the name of the peer group to enter the remote AS into routing tables of all routers within the peer group. Enter a number of the AS. Range: 1 to 65535. Defaults Not configured. Command Modes ROUTER BGP IPv6 Border Gateway Protocol (IPv6 BGP) | 769