Dell Force10 S50-01-GE-48T FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 1083
show ipv6 ospf neighbor
View all Dell Force10 S50-01-GE-48T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1083 highlights
Parameters interface (OPTIONAL) Enter one of the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series Range: 1-128 E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale. • For a SONET interface, enter the keyword sonet followed by the slot/ port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094 Defaults No default behavior or values Command Modes EXEC Command History Version 7.8.1.0 Version 7.4.1.0 Added support for C-Series Introduced Example Figure 38-28. show ipv6 ospf interface command FTOS#show ipv6 ospf interface gigabitethernet 1/0 GigabitEthernet 1/0 is up, line protocol is up Link Local Address fe80::201:e8ff:fe17:5bbd, Interface ID 67420217 Area 0, Process ID 1, Instance ID 0, Router ID 11.1.1.1 NetworkType BROADCAST, Cost: 1, Passive: No Transmit Delay is 100 sec, State DR, Priority 1 Designated router on this network is 11.1.1.1 (local) No backup designated router on this network Timer intervals configured, Hello 10, Dead 40, Wait 1, Retransmit 5 FTOS# show ipv6 ospf neighbor c e Display the OSPF neighbor information on a per-interface basis. Syntax show ipv6 ospf neighbor [interface] Open Shortest Path First (OSPFv2 and OSPFv3) | 1083