Dell OptiPlex 5055 R Small Form Factor OptiPlex 5055 Small Form Factor Owners - Page 13

LED error code after replacing coin cell battery, Working on your computer, Safety instructions

Get Dell OptiPlex 5055 R Small Form Factor PDF manuals and user guides View all Dell OptiPlex 5055 R Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

Table 2. System board jumper details PW_CLR SERVICE_MODE CMOS_CLR 3-4 Short: Default 3-4 Open: Password: Reset 1-2 Short: Disable 1-2 Open: Default 5-6 Short: CMOS Reset 5-6 Open: Default LED error code after replacing coin cell battery After replacing the coin-cell battery, the system will not power on and the LED blinks 2-2 in amber. This is a known behavior when the super I/O is reset to default. Press and hold the power button until the system powers on. Working on your computer Safety instructions Use the following safety guidelines to protect your computer from potential damage and to ensure your personal safety. Unless otherwise noted, each procedure included in this document assumes that the following conditions exist: ● You have read the safety information that shipped with your computer. ● A component can be replaced or, if purchased separately, installed by performing the removal procedure in reverse order. Field service information 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
Table 2. System board jumper details
PW_CLR
3-4 Short: Default
3-4 Open: Password: Reset
SERVICE_MODE
1-2 Short: Disable
1-2 Open: Default
CMOS_CLR
5-6 Short: CMOS Reset
5-6 Open: Default
LED error code after replacing coin cell battery
After replacing the coin-cell battery, the system will not power on and the LED blinks 2-2 in amber. This is a known behavior
when the super I/O is reset to default. Press and hold the power button until the system powers on.
Working on your computer
Safety instructions
Use the following safety guidelines to protect your computer from potential damage and to ensure your personal safety. Unless
otherwise noted, each procedure included in this document assumes that the following conditions exist:
●
You have read the safety information that shipped with your computer.
●
A component can be replaced or, if purchased separately, installed by performing the removal procedure in reverse order.
Field service information
13