Dell OptiPlex 5055 R Small Form Factor OptiPlex 5055 Small Form Factor Owners - Page 47

Installing the system board, Route all the cables through the routing clips.

Get Dell OptiPlex 5055 R Small Form Factor PDF manuals and user guides View all Dell OptiPlex 5055 R Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals

Page 47 highlights

Installing the system board 1. Hold the system board by its edges and align it toward the back of the computer. 2. Lower the system board into the chassis until the connectors at the back of the system board. 3. Align with the slots on the chassis, and the screw holes on the system board align with the standoffs on the computer. 4. Replace the screws that secures the system board to the computer. 5. Route all the cables through the routing clips. 6. Align the cables with the pins on connectors on the system board and connect the following cables to the system board: a. Intrusion switch b. Optical drive c. Hard drive d. PSU e. Power switch f. Power distribution for optical drive and hard drive 7. Install the: a. Expansion card b. Memory module c. Heat sink assembly d. SD card Field service information 47

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
Installing the system board
1.
Hold the system board by its edges and align it toward the back of the computer.
2.
Lower the system board into the chassis until the connectors at the back of the system board.
3.
Align with the slots on the chassis, and the screw holes on the system board align with the standoffs on the computer.
4.
Replace the screws that secures the system board to the computer.
5.
Route all the cables through the routing clips.
6.
Align the cables with the pins on connectors on the system board and connect the following cables to the system board:
a.
Intrusion switch
b.
Optical drive
c.
Hard drive
d.
PSU
e.
Power switch
f.
Power distribution for optical drive and hard drive
7.
Install the:
a.
Expansion card
b.
Memory module
c.
Heat sink assembly
d.
SD card
Field service information
47