Dell OptiPlex 5055 R Small Form Factor OptiPlex 5055 Small Form Factor Owners - Page 42
Installing power switch, cooling shroud, optical drive, 5 inch hard drive assembly, front bezel
View all Dell OptiPlex 5055 R Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
d. cooling shroud e. optical drive 3. To release the power switch: a. Disconnect the power switch cable from the system board [1]. b. Press the power switch retention tabs and pull out from the computer [2, 3]. Installing power switch 1. Slide the power switch module into the slot on the chassis until it clicks into place. 2. Connect the power switch cable to the connector on the system board. 3. Install the: a. optical drive b. cooling shroud c. 2.5 inch hard drive assembly d. front bezel e. Side cover 4. Follow the procedure in After working inside your computer. 42 Field service information
d.
cooling shroud
e.
optical drive
3.
To release the power switch:
a.
Disconnect the power switch cable from the system board [1].
b.
Press the power switch retention tabs and pull out from the computer [2, 3].
Installing power switch
1.
Slide the power switch module into the slot on the chassis until it clicks into place.
2.
Connect the power switch cable to the connector on the system board.
3.
Install the:
a.
optical drive
b.
cooling shroud
c.
2.5 inch hard drive assembly
d.
front bezel
e.
Side cover
4.
Follow the procedure in
After working inside your computer
.
42
Field service information