Dell OptiPlex 5055 R Small Form Factor OptiPlex 5055 Small Form Factor Owners - Page 32

Installing heat sink assembly

Get Dell OptiPlex 5055 R Small Form Factor PDF manuals and user guides View all Dell OptiPlex 5055 R Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals

Page 32 highlights

a. Disconnect the heat sink assembly cable from the connector on the system board [1]. b. Loosen the 6 captive screws that secure the heat sink assembly to the system board [2]. NOTE: Loosen the screws based on the numbers available on the system board. c. Lift the heat sink assembly away from the computer [3]. Installing heat sink assembly 1. Align the screws of the heat sink assembly with the holders on the system board. 2. Place the heat sink assembly on the processor. 3. Replace the 6 captive screws to secure the heat sink assembly to the system board. NOTE: Tighten the screws based on the order given in the system board. 4. Connect the heat sink assembly cable to the connector on the system board. 5. Install the: a. optical drive b. cooling shroud c. 2.5 inch hard drive assembly d. front bezel e. Side cover 6. Follow the procedure in After working inside your computer. 32 Field service information

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
a.
Disconnect the heat sink assembly cable from the connector on the system board [1].
b.
Loosen the 6 captive screws that secure the heat sink assembly to the system board [2].
NOTE:
Loosen the screws based on the numbers available on the system board.
c.
Lift the heat sink assembly away from the computer [3].
Installing heat sink assembly
1.
Align the screws of the heat sink assembly with the holders on the system board.
2.
Place the heat sink assembly on the processor.
3.
Replace the 6 captive screws to secure the heat sink assembly to the system board.
NOTE:
Tighten the screws based on the order given in the system board.
4.
Connect the heat sink assembly cable to the connector on the system board.
5.
Install the:
a.
optical drive
b.
cooling shroud
c.
2.5 inch hard drive assembly
d.
front bezel
e.
Side cover
6.
Follow the procedure in
After working inside your computer
.
32
Field service information