Dell OptiPlex 5055 R Small Form Factor OptiPlex 5055 Small Form Factor Owners - Page 38
Installing SD card reader, Power supply unit, Removing power supply unit — PSU
View all Dell OptiPlex 5055 R Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Installing SD card reader 1. Place the SD card in the slot on the system board. 2. Tighten the 6 screw to secure the SD card reader to the front panel door. 3. Install the: a. M.2 PCIe SSD b. optical drive c. cooling shroud d. 2.5 inch hard drive assembly e. front bezel f. Side cover 4. Follow the procedure in After working inside your computer. Power supply unit Removing power supply unit - PSU 1. Follow the procedure in Before working inside your computer. 2. Remove the: a. Side cover b. front bezel c. 2.5 inch hard drive assembly d. cooling shroud e. optical drive 3. To release the PSU: a. Disconnect the PSU cables from the connectors on the system board [1]. b. Un-route the PSU cables from the retention clips [2, 3]. 38 Field service information