Dell OptiPlex 5055 R Small Form Factor OptiPlex 5055 Small Form Factor Owners - Page 34

Intrusion switch, Removing intrusion switch

Get Dell OptiPlex 5055 R Small Form Factor PDF manuals and user guides View all Dell OptiPlex 5055 R Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals

Page 34 highlights

2. Align the pin-1 indicator of the processor with the triangle on the socket. 3. Place the processor on the socket such that the slots on the processor align with the socket keys. 4. Close the processor shield by sliding it under the retention screw. 5. Lower the socket lever and push it under the tab to lock it. 6. Install the: a. heat sink assembly b. optical drive c. cooling shroud d. 2.5 hard drive assembly e. front bezel f. Side cover 7. Follow the procedure in After working inside your computer. Intrusion switch Removing intrusion switch 1. Follow the procedure in Before working inside your computer. 2. Remove the: a. Side cover b. front bezel c. cooling shroud 3. To the intrusion switch: a. Disconnect the intrusion switch cable from the connector on the system board [1]. b. Slide the intrusion switch and push it to remove from the chassis [2]. 34 Field service information

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
2.
Align the pin-1 indicator of the processor with the triangle on the socket.
3.
Place the processor on the socket such that the slots on the processor align with the socket keys.
4.
Close the processor shield by sliding it under the retention screw.
5.
Lower the socket lever and push it under the tab to lock it.
6.
Install the:
a.
heat sink assembly
b.
optical drive
c.
cooling shroud
d.
2.5 hard drive assembly
e.
front bezel
f.
Side cover
7.
Follow the procedure in
After working inside your computer
.
Intrusion switch
Removing intrusion switch
1.
Follow the procedure in
Before working inside your computer
.
2.
Remove the:
a.
Side cover
b.
front bezel
c.
cooling shroud
3.
To the intrusion switch:
a.
Disconnect the intrusion switch cable from the connector on the system board [1].
b.
Slide the intrusion switch and push it to remove from the chassis [2].
34
Field service information