Epson EPL-N1200 User Manual - Page 77
Caution, module with the two screws that came with it.
View all Epson EPL-N1200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
5. Now set the jumper and slide switch settings on the LocalTalk/Serial module for the type of interface you'll be using: RS-232C serial, current loop serial, or LocalTalk (default). c Caution: Make sure both slide switches are set to the same position or the printer will not operate correctly. 6. Position the module as shown below; then align its connector with connector CN4 on the controller board. Secure the module with the two screws that came with it. 4-6 Installing Options
5.
Now set the jumper and slide switch settings on the
LocalTalk/Serial module for the type of interface you’ll be
using: RS-232C serial, current loop serial, or LocalTalk
(default).
c
Caution:
Make sure both slide switches are set to the same position
or the printer will not operate correctly.
6.
Position the module as shown below; then align its connector
with connector CN4 on the controller board. Secure the
module with the two screws that came with it.
4-6
Installing Options