Gateway E-9525R Gateway E-9525R Server User Guide - Page 44
Removing and installing a diskette drive
View all Gateway E-9525R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
CHAPTER 4: Installing Components 4 If you are replacing a hard drive, remove the four screws that secure the old hard drive to the drive tray, then remove the drive from the tray. If you are installing a new drive, remove the dummy hard drive from the drive tray. 5 Using the four screws you removed, install the new hard drive into the drive tray. 6 Make sure that the tray's release lever is open, then slide the new drive fully into the empty hot-swap drive bay. 7 Push the lever back into place to secure the hard drive in the bay. 8 Reinstall the bezel, if required, by snapping it into place on the front of the chassis. Removing and installing a diskette drive To remove and install a diskette drive: Caution The diskette drive is not hot-swappable. Before installing or removing the drive, make sure that power is turned off and the power cord(s) is unplugged. 1 Follow the instructions in "Preventing static electricity discharge" on page 30. Make sure that you turn off the server, then unplug the power cord(s) and all other cables connected to the server. 2 Unlock the bezel (if necessary) and remove it by pulling it from the chassis. 3 Follow the instructions in "Opening the server case" on page 31. 4 Disconnect the USB cable from the diskette drive. 5 Lift the blue locking tab on the back of the diskette drive tray, then push the drive tray out the front of the media cage. Blue locking tab 6 Remove the diskette drive from the drive tray, then insert the new diskette drive into the drive tray until it snaps into place. 38