HP 353803-B22 HP StorageWorks 1000 Modular Smart Array maintenance and service - Page 120

Federal Communications Commission. See FCC, 111 Fibre Channel I/O module replacing, 83 figures LEDs controller, 22 fibre channel 1/0 module, 25 firmware cloning, 105 cloning in redundant configurations, 69 updating, 105 floor mats, dissipating, 116 G German noise declaration, 114 ground strap specifications, 116 grounding methods, 62 methods, 115 procedures, 62 straps, wearing, 116 suggested equipment for, 116 H hard drive blank, removing, 72 blank, replacing, 72 ejector levers, 73, 75 latches, 73, 75 LEDs amber, 23 recognizing, 75 reconstructing, 75 removing, 73 removing in fault-tolerant systems, 73 securing, 75 hard drive firmware updating, 109 hazardous conditions symbols on equipment, 63 heel straps, using, 116 help obtaining, 11 hot-pluggable parts, MSA, 67 HP address for FCC questions, 112 series number, 112 technical support, 11 telephone number FCC questions, 112 I I/O EMU removing, 90 IEC EMC, worldwide regulatory compliance notice, 112 illustrated parts breakdown, 13 informational messages array controller restarting, 51 array controller temperature ok, 51 beacon off, 51 beacon on , 50 cache batteries low, recharging, 44 cache disabled no configuration, 44 cache hardware enabled, 43 cache hardware temporarily disabled, 44 cache module # MB, 43 configured volumes, 49 EMU flash done, 53 EMU flash started, 53 fibre subsystem link ok, 56 firmware flash done, 53 firmware flash done on box #, 53 firmware flash started, 53 firmware flash started on box #, 53 firmware version, 35 hard drive hot added box bay, 46 hard drive hot removed box bay, 46 hard drive position change detected, 46 hard drive position charge invalid, 46 initializing fibre subsystem, 55 initializing PCI subsystem, 55 initializing redundancy support, 39 initializing SCSI subsystem, 37 initializing subsystem, 37 MSA1000 active controller, 42 MSA1000 standby controller, 42 new volume(s) detected, 49 no volumes detected, 49 non-compaq hard drive, 46 obsolete cache data deleted, 44 online upgrade complete, 37 online upgrade flashing done, 37 online upgrade flashing firmware, 37 online upgrade flashing started, 37 online upgrade redundancy halted, 37 online upgrade restarting system, 37 persistent mem disabled, 57 persistent mem enabled, 57 recovery ROM autoflash done, 52 recovery ROM autoflash started, 51 redundancy active active controller, 39 redundancy active standby controller, 39 redundancy halted expand active, 40 redundancy halted firmware cloned, 41 replacement hard drive found box, 45 restarting system, 36 ROM cloning done, 52 ROM cloning started, 52 scanning SCSI subsystem, 37 smart hard drive alert box, 46 spares cleared, 50 startup complete, 35 storage box EMU version, 55 120