HP 353803-B22 HP StorageWorks 1000 Modular Smart Array maintenance and service - Page 81
Installing the controller cache module, Installing the controller
UPC - 808736781619
View all HP 353803-B22 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
5. After the battery pack is hooked in position, swing the pack downward, ensuring that the bottom clip and two pegs line up with the holes in the cache module. 6. Verify that the top hook (1) and bottom clip (2) on the battery pack are securely attached to the cache module. 1 2 15520 7. Repeatstep 4 through step 6 to install the second battery pack on the module. 8. Install the serviced cache module in the controller as instructed in Installing the controller cache module. NOTE: The cache is disabled while the batteries are charging and is automatically re-enabled after the batteries are fully charged. Installing the controller cache module 1. Slide the cache module into the controller (1), until the side latches are fully engaged (2). 2 1 15515 2. Close the controller cover. 3. Insert the serviced controller into the chassis as instructed in Installing the controller. Installing the controller 1. Insert the new or serviced array controller into the MSA chassis controller bay (1). 2. Push the controller in as far as it will go, making sure that the controller is seated, and then press the latch handle inward until it is flush against the front panel (2). maintenance and service guide 81