HP Cisco MDS 9020 Cisco MDS 9000 Family Fabric Manager Configuration Guide, Re - Page 1025

Chapter 50 Configuring iSCSI Configuring iSLB Send documentation comments to [email protected] Step 6 Step 7 Step 8 Step 9 Step 10 Step 11 Step 12 Step 13 Step 14 Step 15 Step 16 Step 17 Step 18 Step 19 Step 20 Optionally, check the SystemAssigned check box to have the switch assign the nWWN. Optionally, set the Static WWN field to manually assign the static nWWN. You must ensure uniqueness for this nWWN. Optionally, check the Port WWN Mapping Persistent check box convert dynamic pWWNs to static for the iSLB initiator. See the "Making the Dynamic iSLB Initiator WWN Mapping Static" section on page 50-40. Optionally, check the SystemAssigned check box and set the number of pWWNs you want to have the switch assign the PWWN. Optionally, set the Static WWN(s) field to manually assign the static pWWNs. You must ensure uniqueness for these pWWN. Optionally, set the AuthUser field to the username that you want to restrict the iSLB initiator to for iSLB authentication. Also see the "Restricting iSLB Initiator Authentication" section on page 50-43. Fill in the Username and Password fields to configure iSLB initiator target CHAP authentication. Also see the "Configuring iSLB Session Authentication" section on page 50-43. In the Initiator Specific Target section, set the pWWN to configure an iSLB initiator target. Optionally, set the Name field to a globally unique identifier (IQN). Optionally, check the NoAutoZoneCreation check box to disable auto-zoning. Also see the "Configuring and Activating Zones for iSLB Initiators and Initiator Targets" section on page 50-42. Optionally, check the TresspassMode check box. Also see the "LUN Trespass for Storage Port Failover" section on page 50-53. Optionally, check the RevertToPrimary check box to revert back to the primary port after an HA failover when the primary port comes back up. Set the PrimaryVsan to the VSAN for the iSLB initiator target. Click Create to create this iSLB initiator. If CFS is enabled, select commit from the CFS drop-down menu. Configuring iSLB Initiators This section includes the following topics: • Assigning WWNs to iSLB Initiators, page 50-40 • Making the Dynamic iSLB Initiator WWN Mapping Static, page 50-40 • Assigning VSAN Membership for iSLB Initiators, page 50-40 • Configuring Metric for Load Balancing, page 50-41 • About Load Balancing Using VRRP, page 50-43 • Configuring and Activating Zones for iSLB Initiators and Initiator Targets, page 50-42 • Configuring iSLB Session Authentication, page 50-43 OL-16184-01, Cisco MDS SAN-OS Release 3.x Cisco MDS 9000 Family CLI Configuration Guide 50-39