HP Cisco MDS 9020 Cisco MDS 9000 Family Fabric Manager Configuration Guide, Re - Page 388

Fibre Channel Interfaces Chapter 20 Configuring Interfaces Send documentation comments to [email protected] You can configure the switch to not disable an interface when the threshold is crossed. By default, the threshold disables the interface. Refer to the Cisco MDS 9000 Family CLI Configuration Guide to disable the bit error threshold for an interface. Note Regardless of disabling the switchport ignore bit-error threshold for an interface, the switch generates a syslog message when bit error threshold events are detected. Switch Port Attribute Default Values You can configure attribute default values for various switch port attributes. These attributes will be applied globally to all future switch port configurations, even if you do not individually specify them at that time. Refer to the Cisco MDS 9000 Family CLI Configuration Guide to configure switch port attributes. About SFP Transmitter Types The small form-factor pluggable (SFP) hardware transmitters are identified by their acronyms when displayed. Table 20-5 defines the acronyms used for SFPs (see the "Displaying SFP Transmitter Types" section on page 20-16). Table 20-5 SFP Transmitter Acronym Definitions Definition Acronym Standard transmitters defined in the GBIC specifications short wavelaser swl long wavelaser lwl long wavelaser cost reduced lwcr electrical elec Extended transmitters assigned to Cisco-supported SFPs CWDM-1470 c1470 CWDM-1490 c1490 CWDM-1510 c1510 CWDM-1530 c1530 CWDM-1550 c1550 CWDM-1570 c1570 CWDM-1590 c1590 CWDM-1610 c1610 Displaying SFP Transmitter Types To show the SFP types for an interface using Fabric Manager, follow these steps: 20-16 Cisco MDS 9000 Family CLI Configuration Guide OL-16184-01, Cisco MDS SAN-OS Release 3.x