HP Cisco MDS 9020 Cisco MDS 9000 Family Fabric Manager Configuration Guide, Re - Page 975

Chapter 48 Configuring FCIP Using the FCIP Wizard Send documentation comments to [email protected] Step 5 Step 6 Step 7 Set the RemoteIPAddress and RemoteTCPPort fields for the peer IP address you are configuring. Check the TapeAccelerator check box. (Optional) Set the other fields in this dialog box and click Create to create this FCIP link. To enable FCIP tape acceleration using Fabric Manager, follow these steps: Step 1 Step 2 Step 3 Step 4 Step 5 Step 6 Step 7 From Fabric Manager, choose ISLs > FCIP from the Physical Attributes pane. You see the FCIP profiles and links in the Information pane. From Device Manager, choose IP > FCIP. You see the FCIP dialog box. Click the Tunnels tab. You see the FICP link information. Click the Create Row icon in Fabric Manager or the Create button in Device Manager. You see the FCIP Tunnels dialog box. Set the profile ID in the ProfileID field and the tunnel ID in the TunnelID fields. Set the RemoteIPAddress and RemoteTCPPort fields for the peer IP address you are configuring. Check the TapeAccelerator check box. (Optional) Set the other fields in this dialog box and click Create to create this FCIP link. FCIP Compression The FCIP compression feature allows IP packets to be compressed on the FCIP link if this feature is enabled on that link. By default the FCIP compression is disabled. When enabled, the software defaults to using the auto mode (if a mode is not specified). Note The "auto" (default) mode picks the appropriate compression scheme based on the card type and bandwidth of the link (the bandwidth of the link configured in the FCIP profile's TCP parameters). Table 48-4 lists the modes used for different cards. Table 48-4 Mode mode1 mode2 mode3 Algorithm Classification IPS Card SW SW SW MPS 14/2 Card HW SW SW 18+4/9222i SW HW SW OL-16184-01, Cisco MDS SAN-OS Release 3.x Cisco MDS 9000 Family CLI Configuration Guide 48-37