HP Cisco MDS 9020 Cisco MDS 9000 Family Fabric Manager Configuration Guide, Re - Page 607

Chapter 30 Configuring and Managing Zones Zone Set Duplication Send documentation comments to [email protected] • Migrating a Non-MDS Database, page 30-32 • Clearing the Zone Server Database, page 30-32 Copying Zone Sets On the Cisco MDS Family switches, you cannot edit an active zone set. However, you can copy an active zone set to create a new zone set that you can edit. To make a copy of a zone set using Fabric Manager, follow these steps: Step 1 Choose Edit > Copy Full Zone Database. You see the Copy Full Zone Database dialog box (Figure 30-28). Figure 30-28 Copy Full Zone Database Dialog Box Step 2 Step 3 Step 4 Step 5 Step 6 Cliick the Active or the Full radio button, depending on which type of database you want to copy. Select the source VSAN from the drop-down list. If you selected Copy Full, select the source switch and the destination VSAN from those drop-down lists. Select the destination switch from the drop-down list. Click Copy to copy the database. Caution If the Inter-VSAN Routing (IVR) feature is enabled and if IVR zones exist in the active zone set, then a zone set copy operation copies all the IVR zones to the full zone database. To prevent copying to the IVR zones, you must explicitly remove them from the full zone set database before performing the copy operation. Refer to the Chapter 29, "Configuring Inter-VSAN Routing" for more information on the IVR feature. About Backing Up and Restoring Zones You can back up the zone configuration to a workstation using TFTP. This zone backup file can then be used to restore the zone configuration on a switch. Restoring the zone configuration overwrites any existing zone configuration on a switch. OL-16184-01, Cisco MDS SAN-OS Release 3.x Cisco MDS 9000 Family CLI Configuration Guide 30-29