HP Cisco MDS 9020 Cisco MDS 9000 Family Fabric Manager Configuration Guide, Re - Page 1186

System Message Logging Configuration Chapter 63 Configuring System Message Logging Send documentation comments to [email protected] • When you disable or enable logging to a console session, that state is applied to all future console sessions. If you exit and log in again to a new session, the state is preserved. • When you enable or disable logging to a Telnet or SSH session, that state is applied only to that session. If you exit and log in again to a new session, the state is not preserved. To enable or disable the logging state for a Telnet or SSH session using Fabric Manager, follow these steps: Step 1 Step 2 Step 3 Select a switch in the Fabric pane. Expand Switches, expand Events and select SysLog in the Physical Attributes pane. You see the SysLog information in the Information pane. Click the Switch Logging tab. You see the switch information shown in Figure 63-1. Figure 63-1 Switch Logging Tab in Fabric Manager Step 4 Step 5 Step 6 Select a switch in the Information pane. Check (enable) or uncheck (disable) the Console Enable check box. Click the Apply Changes icon. Console Severity Level When logging is enabled for a console session (default), you can configure the severity levels of messages that appear on the console. The default severity for console logging is 2 (critical). Tip The current critical (default) logging level is maintained if the console baud speed is 9600 baud (default). All attempts to change the console logging level generates an error message. To increase the logging level (above critical), you must change the console baud speed to 38400 baud. . To configure the severity level for a logging facility using Fabric Manager, follow these steps: Step 1 Step 2 Step 3 Select a switch in the Fabric pane. Expand Switches, expand Events and select SysLog in the Physical Attributes pane. You see the SysLog information in the Information pane. Click the Switch Logging tab. 63-4 Cisco MDS 9000 Family CLI Configuration Guide OL-16184-01, Cisco MDS SAN-OS Release 3.x