HP Cisco MDS 9020 Cisco MDS 9000 Family Fabric Manager Configuration Guide, Re - Page 449

Chapter 22 Configuring Generation 2 Switches and Modules Configuring Generation 2 Module Interface Shared Resources Send documentation comments to [email protected] Step 5 Step 6 Select in or out from the Status Service column. Click the Apply Changes icon. . Releasing Shared Resources in a Port Group When you want to reconfigure the interfaces in a port group on a Generation 2 module, you can return the port group to the default configuration to avoid problems with allocating shared resources. Note The interface cannot be a member of a PortChannel. Caution Releasing shared resources disrupts traffic on the port. Traffic on other ports in the port group is not affected. To release the shared resources for a port group using Fabric Manager, follow these steps: Step 1 Step 2 Step 3 Step 4 Select a switch from the Fabric pane, or select a group of switches (SAN, fabric, VSAN) from the Logical Domains pane. Expand Switches > Interfaces and then select FC Physical from the Physical Attributes pane. You see the FC Physical > General tab in the Information pane. Scroll down until you see the row containing the switch and port you want to configure. Scroll right (if necessary) until you see the Status Service column (see Figure 22-12). Figure 22-12 Status Service Column for FC Physical Step 5 Step 6 Step 7 Step 8 Select the out status from the Status Service column. Click the Apply Changes icon. Select the in status from the Status Service column. Click the Apply Changes icon. OL-16184-01, Cisco MDS SAN-OS Release 3.x Cisco MDS 9000 Family CLI Configuration Guide 22-29