HP Cisco MDS 9020 Cisco MDS 9000 Family Fabric Manager Configuration Guide, Re - Page 442

Configuring Generation 2 Module Interface Shared Resources Chapter 22 Configuring Generation 2 Switches and Modules Send documentation comments to [email protected] Figure 22-6 Speed Admin column in Port Configuration The auto parameter enables autosensing on the interface. The autoMax2G parameter enables autosensing on the interface with a maximum speed of 2 Gbps. Note If you change the port bandwidth reservation parameters on a 48-port or 24-port 4-Gbps Fibre Channel switching module, the change affects only the changed port. No other ports in the port group are affected. Step 5 Click the Apply Changes icon. . Configuring Rate Mode To configure the rate mode (dedicated or shared) on an interface on a 48-port or 24-port 4-Gbps Fibre Channel switching module using Fabric Manager, follow these steps: Step 1 Step 2 Step 3 Step 4 Select a switch from the Fabric pane, or select a group of switches (SAN, fabric, VSAN) from the Logical Domains pane. Expand Switches > Interfaces and then select FC Physical from the Physical Attributes pane. You see the FC Physical > General tab in the Interfaces pane. Scroll until you see the row containing the switch and port you want to configure. Select dedicated or shared from the Rate Mode column (see Figure 22-7). Figure 22-7 Rate Mode Port Configuration 22-22 Cisco MDS 9000 Family CLI Configuration Guide OL-16184-01, Cisco MDS SAN-OS Release 3.x