HP Cisco MDS 9020 Cisco MDS 9000 Family Fabric Manager Configuration Guide, Re - Page 501

Chapter 25 Configuring Domain Parameters FC IDs Send documentation comments to [email protected] To configure persistent FC IDs using Fabric Manager, follow these steps: Step 1 Step 2 Expand Fabricxx > VSANxx and then select Domain Manager in the Logical Domains pane for the fabric and VSAN that you want to configure the Persistent FC ID list for. You see the running configuration of the domain in the Information pane. Select the Persistent FcIds tab and click Create Row. You see the Create Persistent FC IDs dialog box shown in Figure 25-10. Figure 25-10 Create Persistent FC IDs Dialog Box Step 3 Step 4 Step 5 Step 6 Select the switch, WWN, and FC ID that you want to make persistent. Set the Mask radio button to single or area. Set the Assignment radio button to static or dynamic. Click the Apply Changes icon to save these changes. About Unique Area FC IDs for HBAs Note Only read this section if the HBA port and the storage port are connected to the same switch. Some HBA ports require a different area ID than storage ports when they are both connected to the same switch. For example, if the storage port FC ID is 0x6f7704, the area for this port is 77. In this case, the HBA port's area can be anything other than 77. The HBA port's FC ID must be manually configured to be different from the storage port's FC ID. Switches in the Cisco MDS 9000 Family facilitate this requirement with the FC ID persistence feature. You can use this feature to preassign an FC ID with a different area to either the storage port or the HBA port. The procedure in this example uses a switch domain of 111(6f hex). The HBA port connects to interface fc1/9 and the storage port connects to interface fc 1/10 in the same switch. Configuring Unique Area FC IDs for an HBA To configure a different area ID for the HBA port using Fabric Manager, follow these steps: OL-16184-01, Cisco MDS SAN-OS Release 3.x Cisco MDS 9000 Family CLI Configuration Guide 25-19