HP Cisco MDS 9020 Cisco MDS 9000 Family Fabric Manager Configuration Guide, Re - Page 955

Chapter 48 Configuring FCIP Using the FCIP Wizard Send documentation comments to [email protected] Figure 48-19 Assigning Profiles to Each Gigabit Ethernet Interface Endpoint Interface FCIP = 51 Profile = 10 Connecting switch (peer) = 10.1.1.1 Switch 1 Endpoint Interface FCIP = 52 Profile = 20 Connecting switch (peer) = 10.100.1.25 Switch 2 FCIP link Virtual (E) ISL Switch 1 IP router IP address of Gigabit Ethernet interface 3/1 = 10.100.1.25 IP network IP router Switch 2 IP address of Gigabit Ethernet interface 3/1 = 10.1.1.1 91562 Verifying Interfaces and Extended Link Protocol To verify the FCIP interfaces and Extended Link Protocol (ELP) on Device Manager, follow these steps: Step 1 Step 2 Step 3 Step 4 Make sure you are connected to a switch that contains an IPS module. Select FCIP from the Interface menu. Click the Interfaces tab if it is not already selected. You see the FCIP Interfaces dialog box. Click the ELP tab if it is not already selected. You see the FCIP ELP dialog box. Checking Trunk Status To check the trunk status for the FCIP interface on Device Manager, follow these steps: Step 1 Step 2 Step 3 Step 4 Make sure you are connected to a switch that contains an IPS module. Select FCIP from the IP menu. Click the Trunk Config tab if it is not already selected. You see the FCIP Trunk Config dialog box. This shows the status of the interface. Click the Trunk Failures tab if it is not already selected. You see the FCIP Trunk Failures dialog box. OL-16184-01, Cisco MDS SAN-OS Release 3.x Cisco MDS 9000 Family CLI Configuration Guide 48-17