HP Cisco MDS 9120 Cisco MDS 9000 Family Storage Media Encryption Configuration - Page 165
Using the Command Line Interface to Con SME, SME Configuration Tasks
View all HP Cisco MDS 9120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 165 highlights
Send documentation comments to [email protected] 7 C H A P T E R Using the Command Line Interface to Configure SME This chapter contains information about Cisco Storage Media Encryption basic configuration using the command line interface (CLI). It contains the following sections: • SME Configuration Tasks, page 7-1 • Enabling and Disabling SME Clustering, page 7-2 • Enabling and Disabling the Cisco SME Service, page 7-2 • Creating the SME Interface, page 7-2 • Deleting the SME Interface, page 7-3 • Creating the SME Cluster, page 7-3 • Setting the SME Cluster Security Level, page 7-4 • Setting Up the Cisco SME Administrator and Recovery Officer Roles, page 7-5 • Adding an SME Interface from a Local or Remote Switch, page 7-5 • Configuring Unique or Shared Key Mode, page 7-6 • Enabling and Disabling Automatic Volume Groups, page 7-6 • Enabling and Disabling Tape Compression, page 7-7 • Enabling and Disabling Key-on-Tape, page 7-7 • Configuring a Tape Volume Group, page 7-8 • Viewing Cisco SME Cluster, Internal, and Transport Information, page 7-8 Caution Before a reboot or before making any changes to the Cisco SME configuration, including adding or deleting SME interfaces, you must enter the copy running-config startup-config CLI command. SME Configuration Tasks The process of configuring SME on an MDS-18/4 module or Cisco MDS 9222i involves a number of configuration tasks that should be followed in chronological order. The configuration tasks included in this process are the following: 1. Enable clustering on the MDS-18/4 module switch. OL-18091-01, Cisco MDS NX-OS Release 4.x Cisco MDS 9000 Family Storage Media Encryption Configuration Guide 7-1