HP Cisco MDS 9120 Cisco MDS 9000 Family Storage Media Encryption Configuration - Page 203

Appendix A Cisco SME CLI Commands interface sme Send documentation comments to [email protected] interface sme To configure the Cisco SME interface on a switch, use the interface sme command. To remove the interface, use the no form of the command. interface sme slot /port no interface sme slot /port Syntax Description slot port Identifies the number of the MSM-18/4 module slot. Identifies the number of the Cisco SME port. Defaults Disabled. Command Modes Configuration mode. Command History Release 3.2(2c) Modification This command was introduced. Usage Guidelines To use this command, clustering must be enabled using the feature cluster command and Cisco SME services must be activated using the feature sme command. Once you have configured the interface, use the no shutdown command to enable the interface. To delete the Cisco SME interface, you must first remove the switch from the cluster. Use the no sme cluster command to remove the switch from the cluster and then use the no interface command to delete the interface. The interface commands are available in the (config-if) submode. Examples The following example configures and enables the Cisco SME interface on the MSM-18/4 module slot and the default Cisco SME port: switch# config terminal switch(config)# interface sme 3/1 switch(config-if)# no shutdown Related Commands Command show interface sme shutdown Description Displays interface information. Enables or disables an interface. OL-18091-01, Cisco MDS NX-OS Release 4.x Cisco MDS 9000 Family Storage Media Encryption Configuration Guide A-15