HP Cisco MDS 9120 Cisco MDS 9000 Family Storage Media Encryption Configuration - Page 196

Appendix A Cisco SME CLI Commands do Send documentation comments to [email protected] do Use the do command to execute an EXEC-level show command from any configuration mode or submode. do command Syntax Description command Specifies the EXEC command to be executed. Defaults None. Command Modes All configuration modes. Command History Release 1.1(1) Modification This command was introduced. Usage Guidelines Use this command to execute EXEC level show commands while configuring your switch. After the EXEC command is executed, the system returns to the mode from which you issued the do command. Examples The following example displays the information about the cluster tape details in the Cisco SME tape volume configuration submode: switch# config t switch(config)# sme cluster c1 switch(config-sme-cl)# tape-bkgrp group1 switch(config-sme-cl-tape-bkgrp)# tape-device devicename1 switch(config-sme-cl-tape-bkgrp-tapedevice)#do show sme cluster clustername1 tape detail Tape t1 is online Is a Tape Drive Model is HP Ultrium 2-SCSI Serial Number is HUM4A00184 Is configured as tape device b1 in tape group b1 Paths Host 12:01:00:e0:8b:a2:08:90 Target 52:06:0b:11:00:20:4c:4c LUN 0x0000 Is online The following example displays the counters in the interface in the Cisco SME crypto tape volume group configuration submode: switch# config t switch(config)# sme cluster c1 switch(config-sme-cl)# tape-bkgrp group1 switch(config-sme-cl-tape-bkgrp)# tape-volgrp t1 switch(config-sme-cl-tape-bkgrp-volgrp)#do show interface sme 3/1 description sme3/1 5 minutes input rate 0 bits/sec, 0 bytes/sec, 0.00 KB/sec 5 minutes output rate 0 bits/sec, 0 bytes/sec, 0.00 KB/sec Cisco MDS 9000 Family Storage Media Encryption Configuration Guide A-8 OL-18091-01, Cisco MDS NX-OS Release 4.x