HP Cisco MDS 9120 Cisco MDS 9000 Family Storage Media Encryption Configuration - Page 55

Chapter 3 Cisco SME Interface Configuration Saving Your Interface Configurations Send documentation comments to [email protected] Viewing Cisco SME Interfaces in Fabric Manager Web Client To view the newly created Cisco SME interfaces, follow these steps: Step 1 In the Physical Attributes pane of the Fabric Manager Web Client, select Interfaces > FC Logical. Step 2 Click the General tab to view the interfaces and their status information. Note After creating the interfaces, you must first configure a Cisco SME cluster and then add the Cisco SME interfaces to the cluster. For details on configuring clusters, see Chapter 4, "Cisco SME Cluster Management." Saving Your Interface Configurations When an SME interface is deleted on one switch in a cluster and then added back, even if the saved SME configurations were the same, the SME interface will not be added back to the cluster. When the switch is reloaded, the SME interfaces will not be added back to the cluster due to a certificate mismatch (because the SME interface was removed and then added back). You would then need to delete the SME interface and add it back and then enter the copy running-config startup-config CLI command. Caution You must enter the copy running-config startup-config CLI command after adding or deleting interfaces or switches as described by the following scenario. OL-18091-01, Cisco MDS NX-OS Release 4.x Cisco MDS 9000 Family Storage Media Encryption Configuration Guide 3-3