HP Dc7700 HP Compaq dc7700 Business Desktop PC Service Reference Guide, 1st Ed - Page 186
Power Supply
UPC - 882780715318
View all HP Dc7700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 186 highlights
Removal and Replacement Procedures - Ultra-Slim Desktop (USDT) Chassis 8.18 Power Supply Å WARNING: Voltage is always present on the system board when the computer is plugged into an active AC outlet. To avoid possible personal injury and damage to the equipment, the power cord should be disconnected from the computer and/or the AC outlet before opening the computer. 1. Prepare the computer for disassembly (Section 8.1). 2. Remove the computer access panel (Section 8.3). 3. Remove the optical drive (Section 8.4). 4. Disconnect the power supply cable from the hard drive and the 6-pin power supply cable on the system board alongside the heatsink. 5. Slide the power supply towards the front of the chassis 1 about 1.3 cm (1/2 inch) then slide it towards the center of the chassis and rotate it up 2 to access the main cable connection beneath it. 6. Disconnect the power cable from the system board. ✎ There are slots on the chassis that match with clips on the bottom of the power supply for positive retention. 7. Remove the power supply from the chassis. To install the power supply, reverse the removal procedure. Make sure the power supply engages the clips on the chassis when sliding it into place. ✎ When installing the power supply make sure the cables are routed properly and do not interfere with the access panel installation. 8-24 433612-001 Service Reference Guide, dc7700