HP HP12C hp 12c_user's guide_English_E_HDPMBF12E44.pdf - Page 114

114 Section 10: Program Editing Keystrokes fs :2?6 Display 6,250.00 25.00 Sets calculator back to Run mode. (Display shown assumes results remain from last example in preceding section.) Copies tax rate from R into R . 2 6 Adding Instructions at the End of a Program To add one or more instructions at the end of the last program stored in program memory: 1. Press fs to set the calculator to Program mode. 2. Press gi. followed by two digits that specify the last line you keyed into program memory (that is, the highest numbered line, not necessarily the line most recently keyed in). 3. Key in the new instruction or instructions. Note: To add one or more instructions at the end of a program that is not the last program stored in program memory, use the procedure described below under Adding Instructions Within a Program. Example: With the last program from the preceding section stored in the calculator, suppose you wanted to add a - instruction at the end in order to calculate the net income after taxes. You could do so as follows: Keystrokes fs gi.08 - fs 15000t Display 0008- 09- 25.00 12,000.00 Sets calculator to Program mode. 25 Sets calculator to last line keyed into program memory. 30 Keys new instruction into program line 09. Sets calculator back to Run mode. Net income after 20% tax is subtracted from $15,000 income. File name: hp 12c_user's guide_English_HDPMBF12E44 Printered Date: 2005/7/29 Page: 114 of 209 Dimension: 14.8 cm x 21 cm