Hitachi 42HDW10 Owners Guide - Page 41
Installation Instructions
View all Hitachi 42HDW10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
INSTALLATION INSTRUCTIONS ENGLISH Installation I No stand is provided with this product. When installing the monitor, use the optional Desk-top Stand (CMPAD05), Wall Mount Unit (horizontal-mount CMPAK04 or CMPAK05, vertical/horizontal-mount CMPAK14), or Ceiling Mount Unit (CMPAT04). The Desk-top Stand has been used for the illustrations in this manual. WARNING • Use one of the special mount units to install this product. A mount of insufficient strength or inadequate design can cause overturning or dropping and result in fire, electrical shock or injury. Please note that our company assumes absolutely no responsibility for personal injuries or property damage caused by use of other mount units or improper installation. • Installation of the wall mount unit and ceiling mount unit can be dangerous, so do not attempt this work yourself. Ask your dealer to provide the name of a qualified installer. CAUTIONS • In order to prevent an internal temperature increase, maintain a space of 10cm (4 inches : For a desktop set-up) or more between the sides and other objects such as walls, etc., so that the ventilation holes are not blocked.* Anti-tumble measures CAUTIONS • Have this unit mounted in a stable place. Take measures to prevent it from tumbling down to avoid possible physical injury. Securing to a wall or pillar 1)Using a commercially available cord, chain and clamp, secure the set to a firm wall or pillar. 10cm (4 inches) or more* Clamp cChooarridn Securing desktop 1)Using wood screws (two), fasten the set to the clamping screw holes on the rear of the stand as shown. 2)Using commercially available wood screws, secure the set firmly in position. Wood screw Two places Using the optional vertical-mount unit (CMPAK14) Using the optional wall-mount unit (CMPAK14) allows set to mount on wall surfaces as shown at right. 1) Make at least four sets of commercial anchor bolts and screws available to meet various kinds of walls to mount on. 2) Read the instructions supplied with the wall-mount unit carefully to optimally locate the plasma display on a wall surface. 3) Prepare the wall surface for anchoring and drilling as needed, as shown in the sketches. • Make sure that an adequate wall surface strength and a screw holding strength are available. Horizontal mounting Upper left vertical mounting I Horizontal mounting Plasma display outline I Upper left vertical mounting Plasma display outline SPEAKER TERMINAL 8Ω 8W SPEAKER TERMINAL 8Ω 8W SPEAKER TERMINAL 8Ω 8W SPEAKER TERMINAL 8Ω 8W Driving anchor bolts into a wall surface Wall surface Anchor bolt Hold to 25 mm (1 inch) or below. CAUTION • The mounted unit should have the indicating lamp at its bottom. Otherwise, an elevated internal temperature rise could cause the unit to fail or fire. 3