Hitachi 42HDW10 Owners Guide - Page 45
Connecting to Video Equipment
View all Hitachi 42HDW10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
ENGLISH Connecting to Video Equipment (such as a Laser Disc player, a DVD player, a DSS,or a Video Camera) I Read SAFETY GUIDELINES ( I to VII ) carefully to ensure maximum safety before proceeding to these steps: 1) Choose an appropriate site and install the product on a level table where the stand is secure. • Install the monitor to have ready access to a power socket available. 2) Make sure that the video equipment's power switch is off. 3) Interconnect the signal input terminal on the monitor rear panel and the video equipment's signal output terminal to each other using an commercially available video cable. 4) Insert one end of the power cable included into the rear-panel power cable connector and the other end into a power socket. 5) Turn on the monitor, then the video equipment's to make sure that a display image appears on the monitor screen. • For instructions on turning on the monitor and adjusting its display images, see "Operating Instructions" ( 9 to 19 ). Speaker (R) Monitor rear panel Speaker (L) External Monitor Power cable connector Power cable AUDIO IN R L/MONO AUDIO IN R L/MONO VIDEO 2 COMPONENT PR/CR PB/CB Y VIDEO 1 COMPOSITE S IN OUT IN Video equipment (such as a video disc player, a DVD player, and a video camera) VIDEO 1 COMPOSITE S IN OUT IN To component input terminals To audio output terminals White(L) Red(R) To component output terminals Yellow(V) White(L) Red(R) To S video output terminals To audio/video output terminals To S video input terminals To component output terminals Yellow(V) White(L) Red(R) White(L) To audio input Red(R) terminals To audio/ video input terminals To component input terminals Use if the video equipment has an S video input terminal • If video equipment with an S video output terminal is used, cabling by the S video cable is recommended to provide finer video quality. (If an S video input terminal and a video input terminal connect to the monitor at the same time, S video input would govern.) • If video equipment is equipped with component video output (Y, PB, PR or Y, CB, CR), please connect to the corresponding color (Y, PB, PR) input jack on the component input of the monitor. • If the VIDEO1 OUT terminal is connected to an external monitor with a 75 Ohm terminal, it is possible to view the same image as on the main unit. If an external monitor is not being used, the cable must be removed from the VIDEO OUT terminal. The image will appear white as saturation level is reached. NOTE : Y to Y, PB-CB to PB, PR-CR to PR. 7