Icom IC-M92D Instruction Manual - Page 102
Troubleshooting
View all Icom IC-M92D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
13 TROUBLESHOOTING PROBLEM POSSIBLE CAUSE SOLUTION REF. The transceiver does • The Battery is exhausted or over dis- • Recharge the battery pack. not turn ON. charged. • The Battery pack is notcorrectly attached. • Correctly attach the battery pack. p. 89 p. 3 Little or no sound comes • The squelch level is set too high. from the speaker. • The volume level is set too low. • The speaker has been exposed to water. • Water has entered to [SP/MIC] connector. • Set the squelch to the threshold point. p. 13 • Set the volume to a suitable level. • Remove the water with the AquaQuake func- p. 15 tion. • Dry [SP/MIC] connector - Transmitting is impos- • Some channels are programmed for low • Change channels. sible power or receive only by regulations. • The battery is exhausted. • Recharge the battery pack. • The battery is overcharged. • Verify the battery voltage is correct. • The output power is set to low. • Push [HI/LO] to select high power. p. 11 p. 91 p. 14 Scan does not start. • Favorite channels are not programmed. • Set the desired channels as Favorite chan- p. 18 nels. No beeps sound. • Beep tones are turned OFF. • Turn the beep tones ON in the CONFIGURA- p. 85 TION menu. Distress calls cannot be • MMSI (DSC self ID) code is not pro- • Program the MMSI (DSC self ID) code. transmitted. grammed. p. 10 95