Icom IC-M92D Instruction Manual - Page 76
DDSC Loop Test DChannel 70 Watch function
View all Icom IC-M92D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
New2001 8 DSC OPERATION D DSC Loop Test The DSC loop test function sends transmit DSC signals to the receive AF circuit to compare and check the TX and RX signals at the AF level. q Enter "DSC LOOP TEST" in the DSC Settings menu. ❮MENU❯ ➪ ❮DSC Settings❯ ➪ ❮DSC Loop Test❯ (Push [MENU]) (Push [Y]/[Z], then push [ENTER].) w Push [ENTER] to start the DSC loop test. • Push [BACK] to cancel and return to the DSC Settings menu. D Channel 70 Watch function Select whether or not the transceiver monitors Channel 70. q Enter "CH 70 Watch" in the DSC Settings menu. ❮MENU❯ ➪ ❮DSC Settings❯ ➪ ❮CH 70 Watch❯ (Push [MENU]) (Push [Y]/[Z], then push [ENTER].) w Push [] or [] to set the Channel 70 Watch function to "OFF with Power Save," "OFF," "Busy" or "Standby," then push [ENTER]. • Push [BACK] to cancel and return to the DSC Settings menu. (default) • When the transmit DSC and receive DSC signals are matched, "OK" appears. e Push [EXIT] to return to the normal operating mode. If "NG" appears in step w, either or both TX and RX DSC circuits has a problem. In that case, you will have to send the transceiver to your nearest dealer for repair. New 69