JVC DLA-QX1G Instruction Manual - Page 15
Connector Panel Cont.
View all JVC DLA-QX1G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Connector Panel (Cont.) About the optional VICs HDTV Analog VIC Å LED This LED lights up when the HDTV Analog VIC is selected. ı Y, Pb, Pr input terminal (BNC x 3) These are Y, Pb, Pr input terminals for HD signal (SMPTE260M/274M/296M). HD-SDI VIC Å LED This LED lights up when the HD-SDI VIC is selected. ı SDI input/output (through) terminal (BNC x 2) These are input and output terminals for HD-SDI signal (SMPTE292M). Å HDTV Analog VIC Y Pb Pr ı Å ı HD-SDI VIC IN OUT ENGLISH How to install the optional VICs 1 Remove the slot panel from the slot of the projector. 1) Remove two screws on the slot panel, one on each end, from an empty slot. 2) Take off the slot panel. 2 Install the VIC. 1) Aligning both ends of the PC board of the VIC with the grooves inside the slot, insert the VIC into the slot. 2) Push the VIC fully so that two connectors on inner surface of the VIC are securely plugged into the sockets inside the slot. 3 Fasten the VIC to the projector. After inserting the VIC into the slot, fasten it to the projector with two screws attached to the VIC. CONTROL REMOTE RS-232C OUT RS-232C IN R G H/CS RGB Analog VIC BY CONTROL REMOTE RS-232C OUT RS-232C IN R G H/CS RGB Analog VIC BY RGHDBTAVnaAlnoagloVgICVIC B G Pr H/CS R Y Pb Y CONTROL REMOTE RS-232C OUT RS-232C IN B G H/CS RGB Analog VIC RY Pr HDTV Analog VIC Y Pb Notes • To avoid penetrating of the dust, do not remove the slot panel from the unused VIC slot. • When replacing the slot panel, set it with the arrow up (indicated on the both ends of the slot panel) as shown: arrow 13