JVC DLA-QX1G Instruction Manual - Page 33
Connecting the Power Cord Supplied
View all JVC DLA-QX1G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Connecting to Various Devices (Cont.) Connecting the Power Cord (Supplied) After all devices have finished being connected, connect the projector's power cord. At this time, do not turn on the MAIN POWER switch yet. • Do not turn on the projector without installing the lens unit (not supplied). Doing so will cause the lens-hole blind cover (black one) initially installed to be deformed by heat from the light-source lamp. I Preparation for United Kingdom only Attach a plug which matches your wall outlet to the power code. For details, consult your dealer. STAND BY OPERATE VIC SELECT 1 2 MODE KEY STONE 3 EXIT MENU T ZOOM FOCUS W ENTER CONTROL REMOTE RS-232C OUT RS-232C IN R G H/CS RGB Analog VIC BV 1 Insert the supplied power cord into the power input terminal (AC IN ) of the projector. 1. Remove the power input terminal cover. The cover is a screwed type. Turn the cover in the direction of the arrow to remove. 1 Power cord (supplied) To wall AC outlet CAUTIONS 2 200 V to 240 V, single phase To prevent fire and electric shock, observe the following: • When you do not use the devices, pull out their power cords from wall outlets. • Do not connect the devices with power cords other than supplied. • Do not use voltage other than the power voltage indicated. • Do not scar, damage, or work on the power cords. Also, do not put a heavy object on, heat or pull the power cords, otherwise they may be damaged. • Do not insert or pull out the plugs with a wet hand. 2. Insert the plug of the supplied power cord into the power input terminal of the projector. Align the groove on the projector plug of the power cord with the claw on the power input terminal of the projector, and push the plug in firmly. After that, turn the ring on the plug in the direction of the arrow to fix. 2 Insert the plug of the supplied power cord into a wall outlet. I To use the projector • Remove the lens cap before using the projector. 3 (For U.S.A. only) Turn the plug to the right to fix. CAUTIONS • Be sure to remove the cap; otherwise, it may be deformed (or degraded in quality) or melted, possibly causing a fire or malfunction. • Do not operate the projector with the lens cap attached. Doing so can deform the lens cap because of the heat. A metallic lens cap can get hot and cause injury. CAUTIONS • Since the power requirement of the projector is high, be sure to insert the power plug directly into a wall outlet. • This projector requires a single phase, 3-wire, 200V to 240V wall outlet. ENGLISH Lens cap 31