JVC DLA-QX1G Instruction Manual - Page 39

Basic Operations (Cont.) I Projector's buttons KEYSTONE buttons EXIT button HIDE VIC SELECT 1 KEY STONE 2 3 EXIT I Removing the trapezoidal distortion of the image (KEYSTONE) If the image projected on the screen is distorted in trapezoid form, correct it with the KEYSTONE buttons. When the KEYSTONE button is pressed, the keystone indication appears on the screen. Keystone 115 Keystone indication Press the KEYSTONE / buttons: The trapezoid form is corrected as shown in the figure. STAND BY OPERATE VIC SELECT 1 MODE KEY STONE 2 3 EXIT MENU T ZOOM FOCUS W ENTER CONTROL REMOTE RS-232C OUT RS-232C IN R G H/CS RGB Analog VIC BV I Remote control unit OPERATE HIDE BACK LIGHT LOCK UNLOCK ENTER EXIT button KEYSTONE buttons EXIT MENU VIC 1 VIC 2 VIC 3 T ZOOM W SHIFT FOCUS ON KEYSTONE SHUTTER OFF T DIGITAL ZOOM W RM-MQX1G REMOTE CONTROL UNIT Remote control unit KEYSTONE Projector KEY STONE Notes • Before adjusting the trapezoidal distortion, adjust the shift setting. For details, refer to page 38. • The trapezoidal distortion (keystone) can be adjusted within the range of 0 to 127. • Adjustable range for correcting trapezoidal distortion (keystone) is 0˚ to +15˚. When "Aspect" or "Panel" is selected as the Resize setting (see page 44), the adjustable range is limited as follows: - While UXGA or SXGA signals are inputted, the range is 0˚ to +10˚. - While analog HD signals are inputted, you cannot make any adjustment. • The trapezoidal distortion (keystone) can be adjusted from the menu. For details, refer to page 46. • Interference patterns may appear on the screen when adjusting the keystone. This is not a malfunction. • Depending on the type of signal, some noise may appear in the picture when the keystone is adjusted. In this case, consult your dealer. ENGLISH (To be continued on the next page) 37