JVC DLA-QX1G Instruction Manual - Page 22
Installing the Projector against the Screen
View all JVC DLA-QX1G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Installing the Projector (Cont.) Installing the Projector against the Screen The projector should be placed so that the center line of the lens is at a right angle to the screen as shown in the following figures. I Normal projection I Projection through the glass STAND BY OPERATE HIDE VIC SELECT 1 KEY STONE 2 3 EXIT MENU T ZOOM FOCUS ENTER W CONTROL REMOTE RS-232C OUT RS-232C IN RGB Analog VIC R G B Y H/CS STAND BY OPERATE HIDE VIC SELECT 1 KEY STONE 2 3 EXIT MENU T ZOOM FOCUS ENTER W CONTROL REMOTE RS-232C OUT RS-232C IN RGB Analog VIC R G B Y H/CS I Inclined projection 3.55° STAND BY OPERATE HIDE VIC SELECT 1 KEY STONE 2 3 EXIT MENU T ZOOM FOCUS ENTER W CONTROL REMOTE RS-232C OUT RS-232C IN RGB Analog VIC R G Y B H/CS • The brightness of the video image reduces when it is projected through the glass. It is not recommended that the video image is projected through the plural glasses. • Even if the projector is not installed at right angles to the glass, you can enjoy the projection through the glass. In this case, adjust the position of the projector and/or the glass to avoid the diffused reflection. I Projection using stack configuration Up to three projectors can be stacked and used together (stack configuration). Using two or more projectors together, high image brightness can be attained. This allows you to project sufficiently bright image in a fairly large auditorium or relatively bright place. STAND BY OPERATE HIDE VIC SELECT 1 KEY STONE 2 3 EXIT MENU T ZOOM FOCUS ENTER W CONTROL REMOTE RS-232C OUT RS-232C IN RGB Analog VIC R G B Y H/CS STAND BY OPERATE HIDE VIC SELECT 1 KEY STONE 2 3 EXIT MENU T ZOOM FOCUS ENTER W CONTROL REMOTE RS-232C OUT RS-232C IN RGB Analog VIC R G B Y H/CS CAUTION • To prevent damage to the projector during shipment, a shift center lock pin was used to fix the lens mechanism when the projector was shipped out the factory. If the lens does not either move up or down by your lens shift adjustment using the buttons on the remote control unit or the setting menu, the shift center lock pin might not have been removed. In this case, consult your dealer or service center. • When using the stack configuration, first install the frame specially designed for the stack configuration. Decide the installation place in the point of stability and efficiency for ventilation. • For the stack configuration, you need to use the lens with the shift function. 20