Konica Minolta bizhub 181 bizhub 181 Twain Driver User Manual - Page 46

Transmission error, Scanning

Get Konica Minolta bizhub 181 PDF manuals and user guides View all Konica Minolta bizhub 181 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 46 highlights

Error messages 5 Transmission error Computer display message: Cause Remedy The machine has not started up. A system crash may have occurred on the computer or the machine during transmission. The USB cable or network cable was not correctly connected during transmission. • Turn off the machine, and then check that the USB cable and network cable are correctly connected. • After checking the USB cable and network cable, turn on the machine again. • If the error is still not corrected, contact your technical representative. 2 Note The network cable can be used only when the optional network interface card NC-503 or image controller IC-206 is installed. Scanning Computer display message: Cause Remedy If a TWAIN scan job is sent at the same time Wait until the copy or scan operation is finas a copy job, the machine may stop while ished. scanning. TWAIN Driver 5-5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
Error messages
5
TWAIN Driver
5-5
Transmission error
Computer display message:
2
Note
The network cable can be used only when the optional network interface
card NC-503 or image controller IC-206 is installed.
Scanning
Computer display message:
Cause
Remedy
The machine has not started up.
•
Turn off the machine, and then check
that the USB cable and network cable
are correctly connected.
•
After checking the USB cable and net-
work cable, turn on the machine again.
•
If the error is still not corrected, contact
your technical representative.
A system crash may have occurred on the
computer or the machine during transmis-
sion.
The USB cable or network cable was not cor-
rectly connected during transmission.
Cause
Remedy
If a TWAIN scan job is sent at the same time
as a copy job, the machine may stop while
scanning.
Wait until the copy or scan operation is fin-
ished.