Kyocera ECOSYS FS-4100DN PRESCRIBE Commands Technical Reference Manual - Rev. - Page 18

Chapter 1 Introduction to PRESCRIBE Figure 1. 9. Logical Page and Physical Page Standard Mode x (0,0) = Logical page y Path Mode −y −x x y With the standard mode logical page, any position specification that lies outside of the logical limits is automatically adjusted to bring it within the limits. For example, the page on the upper left in the preceding figure shows what happens if you attempt to draw a diagonal line from below the bottom edge limit to a point to the right of the right edge limit when the standard mode logical page is used. The fine line represents the line as specified by the user; the thick line shows what is actually drawn by the printing system. With the path mode logical page, coordinates are not adjusted even if they fall outside of the edge limits. In this case, as shown in the lower right page in the preceding figure, the line is defined by the specified starting and ending points, but parts falling outside of the edge limits are clipped. Command Parameters Numeric Parameters Many of the PRESCRIBE commands use number values to specify parameters. For example, numbers are used to specify distances in inches, centimeters, points, or dots. Negative numbers are also allowed. 1-10