Lexmark CX410 User's Guide - Page 152

Understanding printer menus Use Timeouts Hibernate Timeout on Connection Hibernate Do Not Hibernate Timeouts Screen Timeout 15-300 Timeouts Prolong Screen Timeout On Off Timeouts Print Timeout Disabled 1-255 Timeouts Wait Timeout Disabled 15-65535 152 To Set the printer to follow the setting of "Hibernate Timeout" even when an active Ethernet or fax connection exists. Notes: • Do Not Hibernate is the factory default setting. • If "Hibernate Timeout on Connection" is set to Do Not Hibernate, then the device never automatically hibernates. • If "Hibernate Timeout on Connection" is set to Hibernate, then the device follows the value of the "Hibernate Timeout" setting, except when it is set to Disabled. Set the amount of time in seconds the printer waits before returning the printer display to Ready state. Note: 30 is the factory default setting. Set the printer to continue the specified job without returning to the home screen when the screen timeout timer expires. Notes: • Off is the factory default setting. This follows the normal Screen Timeout expires workflow. • On continues to show the same screen and allows the user to reset the Screen Timeout timer instead of returning to the home screen. Set the amount of time in seconds the printer waits to receive an end‑of‑job message before canceling the remainder of the print job. Notes: • 90 is the factory default setting. • When the timer expires, any partially printed page still in the printer is printed, and then the printer checks to see if any new print jobs are waiting. • Print Timeout is available only when using PCL emulation. This setting has no effect on PostScript emulation print jobs. Set the amount of time in seconds the printer waits for additional data before canceling a print job. Notes: • 40 is the factory default setting. • Wait Timeout is available only when the printer is using PostScript emulation. This setting has no effect on PCL emulation print jobs.