Lexmark CX410 User's Guide - Page 192
PCL Emul menu, Image Smoothing, Notes, Font Source, Font Name, Symbol Set, PCL Emulation Settings
View all Lexmark CX410 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 192 highlights
Understanding printer menus Use Image Smoothing On Off PCL Emul menu Use Font Source Resident Disk Download Flash All Font Name Courier 10 Symbol Set 10U PC‑8 12U PC‑850 PCL Emulation Settings Point Size 1.00-1008.00 192 To Enhance the contrast and sharpness of low‑resolution images and smoothen their color transitions. Notes: • Off is the factory default setting. • Image Smoothing has no effect on images that are 300 dpi or higher in resolution. To Specify the set of fonts used by the Font Name menu. Notes: • "Resident" is the factory default setting. Resident shows the factory default set of fonts downloaded in the RAM. • "Flash" and "Disk" settings show all fonts resident in that option. • The flash option must be properly formatted and cannot be read/write‑, write‑, or password‑protected. • "Download" shows all the fonts downloaded in the RAM. • "All" shows all fonts available to any option. Identify a specific font and the option where it is stored. Note: Courier 10 is the factory default setting. Courier 10 shows the font name, font ID, and the storage location in the printer. The font source abbreviation is R for Resident, F for Flash, K for Disk, and D for Download. Specify the symbol set for each font name. Notes: • 10U PC‑8 is the US factory default setting. 12U PC‑850 is the international factory default setting. • A symbol set is a set of alphabetic and numeric characters, punctuation, and special symbols. Symbol sets support the different languages or specific programs such as math symbols for scientific text. Only the supported symbol sets are shown. Change the point size for scalable typographic fonts. Notes: • 12 is the factory default setting. • Point size refers to the height of the characters in the font. One point equals approximately 0.014 inch. • Point sizes can be increased or decreased in 0.25‑point increments.