Lexmark X264 User's Guide - Page 123
Quiet Mode, Notes, Run Initial setup, Paper Sizes, Scan to PC Port Range, Default Mode, Date Format
View all Lexmark X264 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 123 highlights
Understanding printer menus Menu item Quiet Mode Off On Run Initial setup Yes No Paper Sizes U.S. Metric Scan to PC Port Range Default Mode Copy Fax Date Format MM‑DD‑YYYY DD‑MM‑YYYY YYYY‑MM‑DD Time Format 12 hour A.M./P.M. 24 hour clock Alarms Alarm Control Cartridge Alarm Timeouts Power Saver Disabled 1-240 123 Description Reduces the amount of noise produced by the printer Notes: • Off is the factory default setting. • On configures the printer to produce as little noise as possible. Instructs the printer to run the setup wizard Notes: • Yes is the factory default setting. • After completing the setup wizard by selecting Done at the Country select screen, the default setting becomes No. Specifies the printer factory default measurements. The default setting is determined by the country selection in the initial setup wizard. Specifies a valid port range for printers behind a port blocking firewall. The valid ports are specified by two sets of numbers separated by a semicolon. Note: 9751:12000 is the factory default setting. Sets the function the printer enters when Go, Content, Darkness, or any number is pressed on the printer control panel Note: Copy is the factory default setting Formats the printer date Note: MM‑DD‑YYYY is the US factory default setting and DD‑MM‑YYYY is the international factory default setting. Formats the printer time Note: The factory default setting is 12 hour A.M./P.M. Sets an alarm to sound when the printer requires operator intervention. Available selections for each alarm type are: Off Single Continuous Notes: • Single is the factory default setting for Alarm Control. Single sounds three quick beeps. • Off means no alarm will sound. • Continuous repeats three beeps every 10 seconds. Specifies the number of minutes of inactivity before some systems begin entering a minimum power state. Note: 30 minutes is the factory default setting.