Lexmark X264 User's Guide - Page 177

Troubleshooting 177 DO NOT TOUCH Reading flash data DO NOT POWER OFF As a part of this message, a bar graphic appears on one line of the display, indicating the percentage of processing time completed. Wait for the message to clear. The message displays until all code is received and the processing is complete. Warning-Potential Damage: If your printer is connected to a computer by a USB cable, do not touch the printer control panel while this message appears on the display. Do not turn the printer off while this message appears. Fax failed The fax failed to be sent. Wait for the message to clear. Fax Station Name not set up The Fax Station Name has not been entered. Sending and receiving faxes is disabled until fax is configured properly. Try one or more of the following: • Press the arrow buttons until Continue appears, and then press to clear the message. • Enter the Fax Station Name, which can be done in the Settings menu under General Fax Settings or Analog Fax Setup. If the message appears again, then contact your system support person. Fax Station Number not set up The Fax Station Number has not been entered. Sending and receiving faxes is disabled until fax is configured properly. Try one or more of the following: • Press the arrow buttons until Continue appears, and then press to clear the message. • Complete the Analog Fax Setup. If the message appears again, contact your system support person. Formatting Flash DO NOT POWER OFF Wait for the message to clear. Warning-Potential Damage: Do not power off while the printer is formatting the flash memory. Hex Trace The printer is in Hex Trace mode. Invalid Engine Code You need to download valid engine code for the printer. Note: Engine code may be downloaded while this message appears on the display.